Difference between revisions of "Hh2019sweatshop"
Jump to navigation
Jump to search
Line 31: | Line 31: | ||
}} | }} | ||
− | + | {{SweatshopItem | |
− | Audiojacks are not properly soldered, so we'll fix them. | + | |Title=Soldering AudioJacks |
− | * | + | |Subtitle=Audiojacks are not properly soldered, so we'll fix them. |
− | * | + | |Requirements= |
− | * | + | * 2x JBC Soldering station with wide tip (borrow one from Benadski) |
+ | * proper thin solder | ||
+ | |In= | ||
+ | * Badge-panels | ||
+ | |Out= | ||
+ | * Badge-panels with better soldered audio jacks -> Depanelizing | ||
+ | }} | ||
==Depanelizing== | ==Depanelizing== |
Revision as of 15:09, 6 February 2019
Contents
Event
Saturday February 9 we will sweatshop 300 badges together :)
Location will be Revspace (The Hague) and we'll start at 13:00. We estimate everything should be done in approximately 2 hours, maybe even less. Maybe more when a crisis arrises ;)
People
- Sebastius
- Jnx
- Renze
- Tom + 1
- Bugblue
- Relocker
- Obitoo
- Jelle
- Rowan8k
- Maeddoc
- Bef0re + 1
- JanHenrik
Stations
Unpacking
Requirements |
|
---|---|
Procedure |
{{{Procedure}}} |
What comes in |
|
What comes out |
|
Soldering AudioJacks
Audiojacks are not properly soldered, so we'll fix them.
Requirements |
|
---|---|
Procedure |
{{{Procedure}}} |
What comes in |
|
What comes out |
|
Depanelizing
- Requirements: tablemounted vice, pliers (combinatietang), trashcan
- What comes in: badge-panels
- Procedure: Use vice to break side-rails off, use pliers to break tabs. Be careful not to scratch/damage/bend boards.
- What comes out: trays with Badges -> display mounting, waste -> trash
Display connecting
- Requirements: wooden picks
- What comes in: trays with badges, trays with displays
- Procedure: slightly bent flat-cable, pass through hole, open connector, insert cable, close connector
- What comes out: trays with badges with display
Software
- Requirements: laptops with software, USB cables and hubs
- What comes in: trays with badges with display
- Procedure: connect badge and wait until autotester appears, if final image shows: pass!
- What comes out: trays with badges that pass -> mounting, trays with badges that fail -> rework
Display Mounting
- Requirements: gluedot-gun, Alklanet, microfibercloth
- What comes in: trays with badges
- Procedure: degrease PCB and display, apply two gluedots on PCB, glue display on PCB
- What comes out: trays with badges with a mounted display -> Bagging
Bagging
- Requirements: Heat-sealer, scissors
- What comes in: trays with badges with a mounted display, ESD bags
- Procedure: Three badges in bags, seal, cut into separate packs.
- What comes out: badges in ESD bags -> Packing
Packing
- Requirements: Badge-kits, HackerHotel stickers, Sponsor Sticker, Revspace sticker, IR Receiver, empty SAMLA crate
- What comes in: badges in ESD bags
- Procedure: add badge, stickers and IR receiver to bag, deflate, ziplock, crate
- What comes out: complete badge kits!