Hh2019sweatshop

From Badge team
Revision as of 16:26, 6 February 2019 by 62.140.137.108 (talk) (→‎People)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigation Jump to search

Event[edit]

Saturday February 9 we will sweatshop 300 badges together :)

Location will be Revspace (The Hague) and we'll start at 13:00. We estimate everything should be done in approximately 2 hours, maybe even less. Maybe more when a crisis arrises ;)

People[edit]

  • Sebastius
  • Jnx
  • Renze
  • Tom + 1
  • Bugblue
  • Relocker
  • Obitoo
  • Jelle
  • Rowan8k
  • Maeddoc
  • Bef0re + 1
  • JanHenrik
  • Stegen

Stations[edit]

Unpacking[edit]

Requirements
  • Empty SAMLA for ESD bags
  • tray for boards
Procedure
What comes in
  • SAMLA boxes with badge-panels
What comes out
  • loose badge-panels on trays -> Soldering station,
  • bags -> Bagging station

Soldering AudioJacks[edit]

Audiojacks are not properly soldered, so we'll fix them.

Requirements
  • 2x JBC Soldering station with wide tip (borrow one from Benadski)
  • proper thin solder
Procedure
What comes in
  • Badge-panels
What comes out
  • Badge-panels with better soldered audio jacks -> Depanelizing

Depanelizing[edit]

Requirements
  • tablemounted vice, pliers (combinatietang), trashcan
Procedure
  • Use vice to break side-rails off
  • use pliers to break tabs.

Be careful not to scratch/damage/bend boards.

What comes in
  • badge-panels
What comes out
  • trays with Badges -> display mounting
  • waste -> trash

Display connecting[edit]

Requirements
  • wooden picks
Procedure

slightly bent flat-cable, pass through hole, open connector, insert cable, close connector

What comes in
  • trays with badges
  • trays with displays
What comes out
  • trays with badges with display

Software[edit]

Requirements
  • laptops with software, USB cables and hubs
Procedure
  • connect badge and wait until autotester appears, if final image shows: pass!
What comes in
  • trays with badges with display
What comes out
  • trays with badges that pass -> mounting
  • trays with badges that fail -> rework

Display Mounting[edit]

Requirements
  • gluedot-gun, Alklanet, microfibercloth
Procedure
  • degrease PCB and display, apply two gluedots on PCB, glue display on PCB
What comes in
  • trays with badges
What comes out
  • trays with badges with a mounted display -> Bagging

Bagging[edit]

Requirements
  • Heat-sealer, scissors
Procedure
  • Three badges in bags, seal, cut into separate packs.
What comes in
  • trays with badges with a mounted display, ESD bags
What comes out
  • badges in ESD bags -> Packing

Packing[edit]

Requirements
  • Badge-kits, HackerHotel stickers, Sponsor Sticker, Revspace sticker, IR Receiver, empty SAMLA crate
Procedure
  • add badge, stickers and IR receiver to bag,
  • deflate
  • ziplock
  • crate
What comes in
  • badges in ESD bags
What comes out
  • complete badge kits!