Event
Saturday February 9 we will sweatshop 300 badges together :)
Location will be Revspace (The Hague) and we'll start at 13:00. We estimate everything should be done in approximately 2 hours, maybe even less. Maybe more when a crisis arrises ;)
People
- Sebastius
- Jnx
- Renze
- Tom + 1
- Bugblue
- Relocker
- Obitoo
- Jelle
- Rowan8k
- Maeddoc
- Bef0re + 1
- JanHenrik
Stations
Unpacking
| Requirements
|
- Empty SAMLA for ESD bags
- tray for boards
|
| Procedure
|
|
| What comes in
|
- SAMLA boxes with badge-panels
|
| What comes out
|
- loose badge-panels on trays -> Soldering station,
- bags -> Bagging station
|
Soldering AudioJacks
Audiojacks are not properly soldered, so we'll fix them.
| Requirements
|
- 2x JBC Soldering station with wide tip (borrow one from Benadski)
- proper thin solder
|
| Procedure
|
|
| What comes in
|
|
| What comes out
|
- Badge-panels with better soldered audio jacks -> Depanelizing
|
Depanelizing
| Requirements
|
- tablemounted vice, pliers (combinatietang), trashcan
|
| Procedure
|
- Use vice to break side-rails off
- use pliers to break tabs.
Be careful not to scratch/damage/bend boards.
|
| What comes in
|
|
| What comes out
|
- trays with Badges -> display mounting
- waste -> trash
|
Display connecting
| Requirements
|
|
| Procedure
|
slightly bent flat-cable, pass through hole, open connector, insert cable, close connector
|
| What comes in
|
- trays with badges
- trays with displays
|
| What comes out
|
- trays with badges with display
|
Software
| Requirements
|
- laptops with software, USB cables and hubs
|
| Procedure
|
- connect badge and wait until autotester appears, if final image shows: pass!
|
| What comes in
|
- trays with badges with display
|
| What comes out
|
- trays with badges that pass -> mounting
- trays with badges that fail -> rework
|
Display Mounting
| Requirements
|
- gluedot-gun, Alklanet, microfibercloth
|
| Procedure
|
- degrease PCB and display, apply two gluedots on PCB, glue display on PCB
|
| What comes in
|
|
| What comes out
|
- trays with badges with a mounted display -> Bagging
|
Bagging
| Requirements
|
|
| Procedure
|
- Three badges in bags, seal, cut into separate packs.
|
| What comes in
|
- trays with badges with a mounted display, ESD bags
|
| What comes out
|
- badges in ESD bags -> Packing
|
Packing
| Requirements
|
- Badge-kits, HackerHotel stickers, Sponsor Sticker, Revspace sticker, IR Receiver, empty SAMLA crate
|
| Procedure
|
- add badge, stickers and IR receiver to bag,
- deflate
- ziplock
- crate
|
| What comes in
|
|
| What comes out
|
|
