Hh2019sweatshop

From Badge team
Revision as of 14:38, 6 February 2019 by Sebastius (talk | contribs) (Created page with " =Stations= ==Unpacking== *Requirements: Empty SAMLA for ESD bags, tray for boards *What comes in: SAMLA boxes with badge-panels *What comes out: loose badge-panels on trays -...")
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigation Jump to search

Stations

Unpacking

  • Requirements: Empty SAMLA for ESD bags, tray for boards
  • What comes in: SAMLA boxes with badge-panels
  • What comes out: loose badge-panels on trays -> Soldering station, bags -> Bagging station

Soldering AudioJacks

Audiojacks are not properly soldered, so we'll fix them.

  • Requirements: 2x JBC Soldering station with wide tip, proper thin solder (borrow one from Benadski)
  • What comes in: Badge-panels
  • What comes out: Badge-panels with better soldered audio jacks -> Depanelizing

Depanelizing

  • Requirements: tablemounted vice, pliers (combinatietang), trashcan
  • What comes in: badge-panels
  • Procedure: Use vice to break side-rails off, use pliers to break tabs. Be careful not to scratch/damage/bend boards.
  • What comes out: trays with Badges -> display mounting, waste -> trash

Display connecting

  • Requirements: wooden picks
  • What comes in: trays with badges, trays with displays
  • Procedure: slightly bent flat-cable, pass through hole, open connector, insert cable, close connector
  • What comes out: trays with badges with display

Software

  • Requirements: laptops with software, USB cables and hubs
  • What comes in: trays with badges with display
  • Procedure: connect badge and wait until autotester appears, if final image shows: pass!
  • What comes out: trays with badges that pass -> mounting, trays with badges that fail -> rework

Display Mounting

  • Requirements: gluedot-gun, Alklanet, microfibercloth
  • What comes in: trays with badges
  • Procedure: degrease PCB and display, apply two gluedots on PCB, glue display on PCB
  • What comes out: trays with badges with a mounted display -> Bagging

Bagging

  • Requirements: Heat-sealer, scissors
  • What comes in: trays with badges with a mounted display, ESD bags
  • Procedure: Three badges in bags, seal, cut into separate packs.
  • What comes out: badges in ESD bags -> Packing

Packing

  • Requirements: Badge-kits, HackerHotel stickers, Sponsor Sticker, Revspace sticker, IR Receiver, empty SAMLA crate
  • What comes in: badges in ESD bags
  • Procedure: add badge, stickers and IR receiver to bag, deflate, ziplock, crate
  • What comes out: complete badge kits!
Retrieved from "https://wiki.badge.team/index.php?title=Hh2019sweatshop&oldid=118"