Hh2019sweatshop

Event

Saturday February 9 we will sweatshop 300 badges together :)

Location will be Revspace (The Hague) and we'll start at 13:00. We estimate everything should be done in approximately 2 hours, maybe even less. Maybe more when a crisis arrises ;)

People

• Sebastius
• Jnx
• Renze
• Tom + 1
• Bugblue
• Relocker
• Obitoo
• Jelle
• Rowan8k
• Maeddoc
• Bef0re + 1
• JanHenrik

Stations

Unpacking

Requirements	Empty SAMLA for ESD bags tray for boards
Procedure	{{{Procedure}}}
What comes in	SAMLA boxes with badge-panels
What comes out	loose badge-panels on trays -> Soldering station, bags -> Bagging station

Soldering AudioJacks

Audiojacks are not properly soldered, so we'll fix them.

Requirements	2x JBC Soldering station with wide tip (borrow one from Benadski) proper thin solder
Procedure	{{{Procedure}}}
What comes in	Badge-panels
What comes out	Badge-panels with better soldered audio jacks -> Depanelizing

Depanelizing

• Requirements: tablemounted vice, pliers (combinatietang), trashcan
• What comes in: badge-panels
• Procedure: Use vice to break side-rails off, use pliers to break tabs. Be careful not to scratch/damage/bend boards.
• What comes out: trays with Badges -> display mounting, waste -> trash

Display connecting

• Requirements: wooden picks
• What comes in: trays with badges, trays with displays
• Procedure: slightly bent flat-cable, pass through hole, open connector, insert cable, close connector
• What comes out: trays with badges with display

Software

• Requirements: laptops with software, USB cables and hubs
• What comes in: trays with badges with display
• Procedure: connect badge and wait until autotester appears, if final image shows: pass!
• What comes out: trays with badges that pass -> mounting, trays with badges that fail -> rework

Display Mounting

• Requirements: gluedot-gun, Alklanet, microfibercloth
• What comes in: trays with badges
• Procedure: degrease PCB and display, apply two gluedots on PCB, glue display on PCB
• What comes out: trays with badges with a mounted display -> Bagging

Bagging

• Requirements: Heat-sealer, scissors
• What comes in: trays with badges with a mounted display, ESD bags
• Procedure: Three badges in bags, seal, cut into separate packs.
• What comes out: badges in ESD bags -> Packing

Packing

• Requirements: Badge-kits, HackerHotel stickers, Sponsor Sticker, Revspace sticker, IR Receiver, empty SAMLA crate
• What comes in: badges in ESD bags
• Procedure: add badge, stickers and IR receiver to bag, deflate, ziplock, crate
• What comes out: complete badge kits!